6
•
Keypad Setup
XX074-02-01 Rev 703 Variable-Speed Keypad
Note: If an alarm occurs when there is no user logged on to a passcoded keypad, the passcode line of the
display shown above will alternate between
Passcode? ----
and
Alarm.
Enter a valid passcode and
acknowledge the alarm as discussed on page 8.
To manually log off of the keypad
, perform the following keystrokes
To automatically log off of the system
, set a log off time as discussed in the
next chapter. You must be a manager to set the auto log off time. Use a time of zero seconds to disable this
function.
To change the number of digits that will define the passcode length
, refer to the Keypad Setup chapter.
Changing the passcode length clears all passcodes and disables the passcode mechanism.
Keypad Setup
Note: (For NOVA mode only.) Before powering your control system, perform the keypad setup described in
this chapter. Make sure to define the keypad baud rate (all keypads in your CCTV system must have
the same baud rate) and keypad address (each keypad must have a unique address). After you have
set up the keypad completely, power your control system and refer to its documentation to set the
Keypad State to
Auto
in the control system programming menus.
To enter Keypad Setup mode, perform the following keystrokes:
Then use the following methods to navigate through and choose a parameter:
To exit Keypad Setup mode, perform the following keystrokes:
Use the table on the next page to define the keypad settings.
Note: When you press A/P to store the contrast as listed in the following table, the joystick center position will also be
stored. Make sure that the joystick is at its center position before pressing A/P. Storing the contrast also initializes
the V1411J-DVC joystick’s zoom function. You must perform the contrast store procedure before you can zoom in
or out with the V1411J-DVC joystick, although zoom keys may be used without performing this procedure.
0
Press & Hold
Press
PROG
Release
PROG
4
Press & Hold
Press
PROG
Release
PROG
A/P
A/I
1
Press & Hold
Press
PROG
Release
PROG
Tilt up/down to display choices.
A/P to save your choice and
move to the next parameter.
A/I to move to the next
parameter without saving.
