2-12
|
Chapter 2 Installation
Surveyor MKII HD Network Dome
13. Lift the Surveyor MKII camera drive up to the housing and attach the
housing’s safety cord clip to the camera drive’s tab. See Figure
below. Allow the drive to hang from the housing.
14. Align the tabs on the camera drive with the slots in the housing,
matching up the arrows on the camera drive and the housing.
Warning
Cables having excessive slack can cause damage to the Surveyor MKII
when installed into the housing.
15. Push the camera drive straight up into the housing until it snaps into
the housing. Do not use excessive force. In the event that it does not
snap easily, remove the Surveyor MKII and verify proper cabling.
16. Insert the clip of the safety cord from the lower dome into the hole on
the inside of the housing. Refer to the installation label provided
inside housing. Holding the lower dome, line up the 2 molded tabs on
the lower dome with the 2 parallel surfaces of the housing. Push the
lower dome up and verify that it snaps into place on both sides. See
Figure below.
