XX077-00-00 Rev 1201 Surveyor2000-MSH Maximum Security Housing
Introduction
••••
3
Introduction
The information in this manual covers the installation, operation, configuration and maintenance of the
Surveyor2000-MSH Maximum Security Housing. This unit should only be installed by a qualified technician
using approved materials in accordance with national, state and local wiring codes. Read this manual through
completely before attempting installation.
Vicon’s Surveyor2000-MSH offers a rugged, tamperproof and IP65 rated enclosure for the Surveyor2000
Camera Dome. The MSH is sold in six (6) prepackaged configurations with choices in camera type. All
versions use the same firmware for programming and operation. For setup and operational information, refer
to the Surveyor2000 Programming Manual XX034. In addition, refer to the Surveyor2000 Installation Manual
XX031 for complete configuration and operation information. This housing can be ceiling or wall mounted with
the appropriate mount. A clear Acrylic Lower Dome is included. Options for this housing are Mounts, Power
Supplies, a Sunshield and a Heater/Blower package as listed in Table 3. Refer to Table 2 for complete
product descriptions.
Surveyor2000-MSH Maximum Security Housing
Components
The MSH consists of a thick steel Enclosure, a sealed Lower Dome assembly, and mounting studs for the
Surveyor2000 Camera Drive. In addition, the Housing provides outside holes for external mounting brackets,
tamperproof hardware for Lower Dome removal and provisional mounting for an optional Heater/Blower unit.
Unpacking and Inspection
All Vicon equipment is tested and inspected before leaving the factory. It is the carrier’s responsibility to
provide suitable delivery. Inspect the cartons upon delivery and, if damage is present, make detailed notes on
the carrier’s bill. Obtain the carrier agent’s signature and file a damage claim as soon as possible.
Open the cartons and inspect the equipment for damage. Save the cartons and packing material. If damage is
present, contact the carrier and file a damage claim immediately. If the equipment must be returned to Vicon
for repair, follow the instructions in the Shipping Information section of this manual.
Accessory Kit
There is one (1) kit included with all configurations of the MSH. It provides the necessary hardware to assist in
assembling and wiring the MSH. The screws and washers are spares for the Lower Dome.
DESCRIPTION
PART NUMBER
QUANTITY
Liquid Tight Conduit Fitting, 1/2 in (13 mm) NPT
8001982204
1
Screw, 8-32 x 1/2 in (13 mm), button head
8003729302
2
Washer, Flat, Nylon
8004948501
2
Bit, Tamperproof, 1/4 in (6.5 mm) hex drive
8003735406
1
Table 1
Accessories
