Vicon Series 247-00-03, Руководство пользователя

Страница: 13 / 77

13
2.3 Unpacking and Inspection
All Vicon equipment is inspected and tested before leaving the factory. It is the carrier’s responsibility
to deliver the equipment in the same condition in which it left the factory.
Inspection for Visible Damage
Immediately inspect the cartons upon delivery. On all copies of the carrier’s freight bill, make a note
of any visible damage.
Make sure the carrier’s agent (the person making the delivery) signs the note on all copies of the bill.
If the agent does not have claim forms, contact the carrier’s office.
Inspection for Concealed Damage
As soon as possible after delivery, unpack the unit and inspect it for concealed damage. Do not
discard the carton or packing materials. If the unit is damaged, contact the carrier immediately and
request forms for filing a damage claim. Make arrangements for a representative of the carrier to
inspect the damaged equipment.
If the equipment must be returned for repair, follow the Shipping Instructions at the end of this
document.
2.4 Physical Installation
The V-CELL is designed to fit into a corner where two walls and a ceiling meet. It is fastened to both
walls and the ceiling. Refer to Figure 1. Cable access is provided by removing the front plate. The
camera has an adjustable mount that may be tilted slightly to give a precise angle of view. A 2.5 mm
wide angle lens enables the camera to view the cell with no “blind spots;” 36 IR LED illuminators are
provided to light up to 66 ft (20 m).
The wall/ceiling material must provide suitable strength to support the weight of the unit (3.5 lb/1.6
kg). Be sure the area around the selected location is clear of obstacles (such as steel beams, headers,
pipes, electrical wiring, etc.) that would interfere with mounting. All cables must be routed to the
installation location. Before beginning installation, read the Cable Recommendations at the end of this
manual and verify that the accessory pack contains the items listed in below table.
Item Quantity Function
No. 20 Torx Bit 1
Use to remove and install tamperproof
screws from front plate
No. 20 Torx Bit 1
Use to remove and install tamperproof
screws from front plate access cover plate
2-Pin Terminal Block 1 Use to make power cable connections
Back Cover 1 Fire barrier;
required for UL/ cUL compliance
Quick Guide/Documentation
CD/ ViconNet CD (IP versions)
1
Installation and operation instructions;
ViconNet setup CD