Vicon S2000-MSH-HHB Surveyor 2000, Руководство по установке и эксплуатации

Страница: 7 / 22

Introduction
The information in this manual covers the installation, operation, configuration and maintenance of the S2000-
MSH-HHB Maximum Security Housing Heater/Blower version. This unit should only be installed by a qualified
technician using approved materials in accordance with national, state and local wiring codes. Read this
manual through completely before attempting installation.
Vicon’s S2000-MSH-HHB (MSH-HHB) offers a rugged, tamperproof and IP65 rated enclosure for the
Surveyor2000 Camera Dome. The MSH-HHB is sold without a S2000 Camera Drive; refer to Table 2 for a list
of compatible drives to accompany the Housing. All versions use the same firmware for programming and
operation. For setup and operational information, refer to the Surveyor2000 Programming Manual XX034. In
addition, refer to the Surveyor2000 Installation Manual XX031 for complete configuration and operation
information. This housing can be ceiling or wall mounted with the appropriate mount; a clear Acrylic Lower
Dome is included. Options for this housing are Mounting Brackets, Power Supplies and a Sunshield as listed
in Table 3.
S2000-MSH-HHB Maximum Security Housing
Components
The MSH-HHB consists of a thick-steel Enclosure, a sealed Lower Dome assembly, a Power Termination
Block and mounting studs for the Surveyor2000 Camera Drive. In addition, the Housing provides outside
holes for external mounting brackets and tamperproof hardware for Lower Dome removal.
Unpacking and Inspection
All Vicon equipment is tested and inspected before leaving the factory. It is the carrier’s responsibility to
provide suitable delivery. Inspect the cartons upon delivery and, if damage is present, make detailed notes on
the carrier’s bill. Obtain the carrier agent’s signature and file a damage claim as soon as possible.
Open the cartons and inspect the equipment for damage. Save the cartons and packing material. If damage is
present, contact the carrier and file a damage claim immediately. If the equipment must be returned to Vicon
for repair, follow the instructions in the Shipping Information section of this manual.
Accessory Kit
There is one (1) kit included with MSH-HHB. It provides the necessary hardware to assist in assembling and
wiring the MSH-HHB. The screws and washers are spares for the Lower Dome.
DESCRIPTION PART NUMBER QUANTITY
Liquid Tight Conduit Fitting, 1/2 in. (13 mm) NPT 8001982204
1
Screw, 8-32 x 1/2 in. (13 mm), button head 8003729302
2
Washer, Flat, Nylon 8004948501
2
Bit, Tamperproof, 1/4 in. (6.5 mm) hex drive 8003735406
1
Table 1
Accessories
XX077-50-00 Rev 1202 S2000-MSH-HHB Heater/Blower Version Introduction
•
3