Vicon Roughneck V926-C26, Руководство по установке и эксплуатации

Страница: 8 / 30

2
•
Installation XX150-06-00 Rev 1010 Roughneck V926 Fixed-Position Camera Dome
Installation
Unpacking and Inspection
All Vicon equipment is tested and inspected before leaving the factory. It is the carrier’s responsibility to
deliver the equipment in the same condition as it left the factory.
Inspection for Visible Damage
Immediately inspect the cartons upon delivery. Make a note of any visible damage on all copies of the
carrier’s freight bill. Make sure the carrier’s agent (the person making the delivery) signs the note on all copies
of the bill. If the agent does not have claim forms, contact the carrier’s office.
Inspection for Concealed Damage
As soon as possible after delivery, unpack the unit and inspect it for concealed damage. Do not discard the
carton or packing materials. If the unit is damaged, contact the carrier immediately and request forms for filing
a damage claim. Make arrangements for a representative of the carrier to inspect the damaged equipment. If
the equipment must be returned for repair, follow the Shipping Instructions at the end of this manual.
Roughneck V926 Components
The Roughneck V926 Camera Dome units consist of a camera module assembly, a mask, and a
polycarbonate lower dome. It includes a 4 x 4 electrical box for cable routing and a ceiling mount bracket. The
camera and lens assembly and lower dome are packed separately.
Camera Module Assembly
The camera module assembly includes an integral camera/lens assembly with pan and tilt adjustment. It is
simply installed onto the camera interface plate. The camera and lens position can be manually adjusted in
three (3) axes, pan, tilt and roll.
Mask
The mask is a textured black polycarbonate plastic shell. It has a slotted opening for the camera. The mask
helps conceal the position of the camera. It has two ribs that align with the pan bracket that allow it to be
adjusted with the camera and lens assembly.
Lower Dome
The lower dome is an assembly comprised of a 4.73 in. (120 mm) diameter impact-resistant polycarbonate
dome and a trim ring. A safety cord is provided on the inside for connection to the camera interface plate.
Refer to the Maintenance section of this manual for instructions on the care and handling of the dome's
surface.