Vicon Roughneck V926-C26, Руководство по установке и эксплуатации

Страница: 9 / 30

XX150-06-00 Rev 1010 Roughneck V926 Fixed-Position Camera Dome Installation
•
3
Accessory Kit
There is one (1) kit included with all configurations of Roughneck V926. It provides the necessary tool to
attach the tamperproof lower dome:
Description Quantity
Tamperproof driver bit, ¼ hex T-15 1
Lens focusing tool 1
Tool for set screw roll adjustment 1
Mounting the Unit
The Roughneck V926 is intended for in-ceiling or in-soffit installation. The primary ceiling surface can be
either a dropped ceiling or a hard ceiling with the thickness not exceeding approximately three (3) inches
(76 mm). Installation is done with the included 4 x 4 electrical box assembly.
Note: Do NOT disassemble the mounting plate/electrical box assembly.
In-Ceiling/In-Soffit Installation
The ceiling material must provide suitable strength to support the weight of the Roughneck V926, which is
approximately 2.5 lb (1.1 kg). Be sure the area above the selected ceiling location is clear of obstacles (such
as steel beams, headers, pipes, electrical wiring, etc.), which would interfere with mounting. Video and power
cables must be routed to the location. Refer to the Cable Recommendations in the Reference section of this
manual.
1. Cut a 4.37 x 4.12 in. (111 x 105 mm) hole in the ceiling at the desired location. Refer to Figure 1 for
mounting dimensions. Remove the tile from a dropped ceiling if necessary. Make sure all necessary
cables are routed to the location.
Figure 1
Mounting Dimensions