Vicon NOVA V1400, Руководство по установке, Страница: 11 / 17

2
•
V1400X-CI-M Control Interface XX007 Rev 702 NOVA V1400
V1400X-CI-M Control Interface
The V1400X-CI-M Control Interface CPU is located in card slot 3 of the NOVA card cage. This CPU module
is connected to receivers 1025-2048 (if needed in your system). You must also use terminators from the
accessory kit on two of the connectors. Remaining connectors are not used. Refer to Figure 2, which shows
V1400X-DL-1 Distribution Line Control (DL) units being used to connect multiple receivers to the system.
Refer to Table 3 for pin connections.
You must fabricate the cables using parts supplied in your accessory kit. Vicon recommends the cables
shown in Table 2. Note that the cables must be shielded using the connector shells.
Table 2
Recommended RS-422 Cable Types
Cable Type Maximum Distance ft (m)
Belden 9406 5000 (1500)
Belden 9402 5000 (1500)
Belden 8723 8000 (2400)
Belden 8162 15,000 (4600)
Belden 9729 15,000 (4600)
Belden 9182 25,000 (7600)
CARD SLOT 3
J3 J4
V1400X-CI-M
J5 J6 J7 J8
1
2
3
4
5
6
J2 J3 J4 J5
Use terminator
from accessory kit. Channel 2
receivers 1792-2048.
Channel 1
receivers
1025-1280.
Up to 9
units per
DL.
V1400X-DL-1
V1400X-DL-1
Not used. Not used.
Dome
Rcvr.
Channel 1
receivers
1537-1791.
Up to 9
units per
DL.
V1400X-DL-1
V1400X-DL-1
Dome
Rcvr.
Use terminator
from accessory kit.
Channel 2
receivers 1281-1536.
Figure 2
Connections to the V1400X-CI-M Control Interface
Note: You may also use Vicon’s
V1400X-IDL Intelligent
Distribution Line Control.