Vicon H264-ENCDR, Руководство по установке

Страница: 19 / 31

18
|
H.264 Encoder Installation and Configuration Guide
Select TAB
The Select TAB allows the user to select the relevant IP Unit in order to
change its settings or to upgrade its version.
1. From the Unit selection list, select the relevant IP product. In case of
multiple sites, it is advised to use the filter under the Unit Type field. Click
on any column tab to sort names by that definition in ascending or
descending order.
2. Once the desired unit has been selected, notice the icon, indicating a
password protected unit. In order to change the selected unit’s settings
on the local PC that is running the VNSetup, a unique password must be
entered. The screen will display how many units there are and how many
of those are password protected (locked). A remote unit, as in systems
using network routers and VLANS (virtual LANs), will not display in the
Unit selection list, as those block network broadcast traffic. If you want to
select a remote unit, manually enter the IP address in the
IP address of
remote unit field and click Find remote unit . The remote unit is added to
the list (if needed use a PC on the same VLAN or network to discover the
device).
3. Password authentication
There are two authentication options. You can either authenticate a
specific unit, by entering its password, or use a Nucleus authentication,
allowing you access to all units in the network that are connected to
that Nucleus.
3.1. Unit authentication - On the Unit password field, enter the unit
password and press the Add password button. Once approved,
notice that the icon has disappeared and the user may
proceed to next phase. The password will be saved on this PC.
Note
The unit password is supplied on the sticker with the MAC address in the
accessory kit package.
3.2. Nucleus authentication - On the Nucleus admin login field, enter
a valid Nucleus IP address and admin password and press the
Login button. Once approved, notice that the icon has
disappeared from all the units currently connected to the
selected Nucleus and the user may proceed to next phase.
4. Press the Select Unit button on the lower section of the screen.