Vicon H264-ENCDR, Руководство по установке

Страница: 16 / 31

H.264 Encoder Installation and Configuration Guide
|
15
Configuring the Encoder
The H264-ENCDR is shipped with one CD that contains the ViconNet
software needed to setup your IP system, including the application setup, the
firmware and setup software (VNSetup). Be sure the ViconNet Workstation
meets the minimum requirements, is running the ViconNet application
(minimum version 6.5) (VNSetup, minimum version 368) and has the proper
PTZ camera driver. The VNSetup is found on the included CD under
software, H264-ENCDR Setup. Refer to appropriate ViconNet
documentation.
Network Considerations
The H264-ENCDR can be connected to any ViconNet network. Kollector
Recorders and ViconNet Workstations/ NVRs can be used for live viewing
and recording of network-streamed video (workstations do not record). A
network can be as simple as a single H264-ENCDR connected to a ViconNet
Workstation or can be complex with the addition of several networks
interconnected via WAN.
When adding a H264-ENCDR to the ViconNet network, the following items
must be considered:

The number of H264-ENCDRs on a switch with respect to switch
capabilities and system bandwidth mapping.

Bandwidth limitations on ports connected to workstations (using 100
or 1000 Mbps).

Workstation capabilities such as processing speed, disk write speed
and display card strength.

Storage size and location types including local Workstation recording,
attached SCSI RAID and integrated NAS/SAN devices.
The default parameters on the IP encoder are:
Factory Defaults Network Defaults
IP address: [1.1.1.2] IP address: [1.1.1.1]
Nucleus IP address: [1.1.1.1] Nucleus IP address: [1.1.1.2]
Net Mask address: [255.255.255.0] Net Mask address: [255.255.255.0]
Gateway address: [1.1.1.1]
Gateway address: [1.1.1.2]
On first startup, the H264-ENCDR will attempt to establish connection to the
Nucleus with the default address (1.1.1.1). Connecting it to an active Nucleus
is done through the VNSetup utility.
.