Vicon Andex 714 T Vario, Руководство по эксплуатации

Страница: 42 / 96

Preparing for use
42
Working depth
When working, the machine is raised and lowered hydraulically. The
machine is lowered as far as the preadjusted depth. The basic setting
for the working depth is adjusted using an adjusting screw on the
chassis cylinder.
•
First set the working depth on the front rotor, because this affects
the pitch of the rear rotor.
Basic working depth
setting
Before the machine is adjusted for use, the following basic settings are
necessary:
Height of the drawbar or lift link drawbar: approx. 400 mm
Check the working depth of both rotors.
Checking the
working depth
Check the preset working depth as follows:
Fix the support wheel in the upper position.
Fully lower the machine using the tractor's hydraulic control device.
Switch off the tractor and secure it.
Check the basic working depth setting:
•
10 mm at the front rotor
•
20 mm at the rear rotor
The ideal working depth depends on several factors. Decisive, among
others, are:
•
The soil condition and the stubble length.
•
The type and quantity of fodder
If the tines are positioned too low, the crop is contaminated and the
stress and wear on the tines, and thus on the drive, increases.
•
If necessary, adjust the working depth to the field again.
10 mm working depth, front rotor
20 mm working depth, rear rotor
400 mm high
hitch
Working depth