Vicon 16CH, Руководство пользователя

Страница: 64 / 158

System Setting
64
| System Setting
Storage
You can configure the settings of and view information of the disk and external storage device.
\ \ disk information
It will show information about the connected disk.
1.
From < SySteM SetUP > - < StoRage >, select < diSk
inFoRMation >.
2.
Use the [
▲▼◀▶
/enteR ] buttons on the remote control
or use the mouse to select either < inteRnal diSkS >
or < exteRnal StoRage >.
Please check the status for each connected device.
i
START / END TIME : show the start time and end time
of data stored in each disk.
i
STATUS : check if the connected disk is being used
by the NVR. If you encounter a problem with the disk,
the NVR will terminate the connection to the disk and
mark it as ‘Not In Use’.
i
CAPACITY : show the capacity of the disk.
i
MODEL : indicate the disk model.
i
S.M.A.R.T STATUS : Read the S.M.A.R.T information
of the disk and check to display if the current disk is in
normal operation.
- NORMAL : The disk is in a normal state.
- CHECK : The disk has an error so that you need to
check the disk or the connection cables of the disk.
If you leave the problem unresolved, no recording
may be enabled. So it is recommended that you
replace the disk immediately.
- ERROR : The disk fails or is unable to use due to an error of the disk or the cable.The disk should be replaced
immediately. Contact the retailer or the customer service to replace the disk.
3.
When done, press the [ exit ] button on the remote control or click < cloSe > in the lower screen to return to the previous
menu.