Viavi T-BERD 5800, Руководство пользователя

Страница: 24 / 100

Chapter 2 Getting Started
Connecting the TEM Module to your test instrument
T-BERD/MTS 5800 Timing Expansion Module User Manual
Page 8 22112315, Rev. 004 July 2017
Connecting the TEM Module to your test instrument
Before connecting your new TEM Module to a T-BERD ⁄ MTS 5800:
• Verify that the instrument is a 5800v2 by checking the label on the back panel of
the instrument, which will indicate whether or not it is a 5800v2. If a module is
connected to the back of the 5800 (obstructing the label), you can assume that
the instrument is a 5800v2; v1 5800’s do not support the connection of additional
modules.
• Power down the 5800, and disconnect the AC power adapter. The TEM Module is
not hot-swappable.
To connect the TEM Module to your test instrument
1 Remove the four screws that hold the back cover in place.
2 Lift off the back cover to expose the connector, then verify that the label indicates
that the instrument is a 5800v2.
NOTE:
The photos supporting steps 5, 6, and 7 of this procedure show an OTDR
Module; the procedure for pivoting, seating, and tightening the screws to
connect the TEM Module to the 5800v2 is exactly the same.