Viadrus Woodpell, Руководство по эксплуатации и установке

Страница: 22 / 40

22
Operating display HWS
Operation of setting HWS
After a brief pressing the key the driver goes over into the mode of editing of setting the temperature
HWS, which is signalled by flashing icon of set temperature. Editing is done by means of buttons or
and then by means of button of shift we go over to the next item. Active setting for editing is signalled by
flashing of given icon or value. After achieving the adequate setting it is necessary not to press any button for
10 seconds. Then the setting will be accepted. After pressing the button of shift at the last flashing value that
is being set the driver goes over into the first position.
Yellow is the marked the value for editing on the given display. The switched off time plan is signalled by
changing the colour of the icon into grey (inactive). Editing the time zone runs on the same screen
Correction of set temperature HWS
The correction is done by means of buttons and and transition between the individual hours takes
place by means of button of shift . The driver allows you to set the corrections from -9 ° C to +9 ° C, or
temporarily turn off central heating (pressing , if the correction is set to -9 °C).
If the controller is in the status STOP (red indicator is on) and we are setting the timetable for UT and TV
equally, then I confirm by pressing . If we have given the plan "stop heating!" then the red indicator will be
blinking.
Temperature
HWS
Actual time Measured
temperature
Mode HWS
Time plan
ON/OFF
Correction of heating
Actual
operation
START
Actual boiler
output
Edited time
Edited time
HWS temporarily
switched off
Time plan
Mode HWS
Correction of
temperature to the
edited time or STOP,
if switched off