VFTech GNOM Super PRO, Руководство оператора

Страница: 16 / 32

v03/2017
16
3. KEYS AND BUTTONS AT THE CONTROL PANEL
Device Settings is done using the control panel located on the front panel of the control unit.

Menu tree:
System start (Моnitor)
 Power
 Temp (Temperature)
 Ver Fw (FW Version)
 Net status (Connection)

Setup

Joystick
 Enable Search
 Choose the type
 Clock

Set current depth sensor as 0
Limiting power motors
Enter to menu: short pressing the button OK
Move around the menu items: buttons 

or

Моnitor
:
This menu allows to view the actual status of device.
Power: - Current and voltage transported to the device and the current consumed by the device.
- Actual devices consumption
Temperature: - Temperature sensor. ZERO indicates that in this set configuration the temperature sensor is not
installed.
Version FW: firmware version
Setting:
This menu allows to the user to set pre-selection.
Joystick: - Selection of type of joystick and switch on the joystick search (pairing) if joystick allows that
Clock: - Setting the clock and date
Set current depth sensor as 0: sensor calibration depth
Limiting power motors: setting of motor power for low speed
Set current depth sensor as 0:
For more accurate measurement of the depth it is recommended to reset the sensor depth before starting work if it
does not indicate 0 ± 0.1 m on the surface. Sensor Reset (set to 0): press and hold for 3 seconds the two
X buttons on
the remote control in the setting mode. It is recommended to do calibration 4-5 minutes after switching on the machine
floating on the water.