Vextrec GMB-486SPS, Руководство пользователя

Страница: 57 / 61

Chapter 5
52
*** NOTE: When either of these errors appear, the system will boot in ISA mode, which allows you to
run the EISA Configuration Utility.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE:
Hard drive cannot be initialized. Be sure the adapter is installed correctly and all cables are correctly and
firmly attached. Also be sure the correct hard drive type is selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER:
Cannot initialize controller. Make sure the cord is correctly and firmly installed in the bus. Be sure the correct
hard drive type is selected in Setup. Also check to see if any jumper needs to be set correctly on the hard drive.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT:
Cannot find or initialize the floppy drive controller. Make sure the controller is installed correctly and firmly.
If there is no floppy drives installed, be sure the Diskette Drive selection in Setup is set to NONE.
Invalid EISA Configuration
PLEASE RUN EISA CONFIGURATION UTILITY:
The non-volatile memory containing EISA configuration information was programmed incorrectly or has
become corrupt. Re-run EISA configuration utility to correctly program the memory.
*** NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the
EISA Configuration Utility.
KEYBOARD ERROR OR NO KEYBOARD PRESENT:
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are being pressed
during the boot.
If you are purposely configuring the system without a keyboard, set the error halt condition in Setup to HALT
ON ALL, BUT KEYBOARD. This will cause the BIOS to ignore the missing keyboard and continue the boot.
Memory Address Error at ...:
Indicates a memory address error at a specific location. You can use this location along with the memory map
for your system to find and replace the bad memory chips.
Memory parity Error at ...
Indicates a memory parity error at a specific location. You can use this location along with the memory map
for your system to find and replace bad memory chips.
MEMORY SIZE HAS CHANGED SINCE LAST BOOT:
Memory has been added or removed since the last boot. In EISA mode use Configuration Utility to
reconfigure the memory configuration. In ISA mode enter Setup and enter the new memory size in the memory
fields.
Memory Verify Error at ...:
Indicates an error verifying a value already written to memory. Use the location along with your system's
memory map to locate the bad chip.
OFFENDING ADDRESS NOT FOUND:
This message is used in conjunction with the I/O CHANNEL CHECK and
RAM PARITY ERROR messages when the segment that has caused the problem cannot be isolated.
OFFENDING SEGMENT:
This message is used in conjunction with the I/O CHANNEL CHECK and