VEVOR VVPS215BUS, Руководство пользователя

Страница: 5 / 12

04
Use Teflon tape on the thread before screw fittings to pump inlet and outlet ports so as to avoid
leakage. Do not over-tighten the fittings.
Warning:
Keep product away from Children.
Before servicing, all water circulation systems and pump controls must be off
position and release all the pressure from the system.
INSTALLATION
Locate the pump as close to the pool and water level as possible. Do not add too many elbow pipes in
the plumbing so as to avoid suction reduction. It is highly recommended that the pump be placed in
cool, dry places and avoid direct sunlight. Install the pump on a firm, level base or pad to meet all local
and national codes. Fasten the pump to the base or pad with screws or bolts to further reduce
vibration and stress on pipe or hose joints. The base must be solid, level, rigid, and vibration-free.
WARNING:
This product should be installed and serviced by a qualified pool professional.
All electrical wiring must be in conformance with applicable local codes, regulations, and
the National Electric Code (NEC).
It is strongly advised to protect the electrical components from direct sunlight though
this pump is designed for outdoor use.
If installed within an outer enclosure or beneath the skirt of a hot tub or spa, adequate
ventilation and free circulation of air must be provided to prevent overheating.
Place this pump in a well-drained area, one that will not flood when it rains.
Do not install this pump in a damp or non-ventilated location. It requires free circulation
of air for cooling.
Do not run the pump dry. Water acts as a coolant and lubricant for the mechanical shaft
seal. Running the pump dry may damage seals, causing leakage, flooding, and voids
warranty. Fill strainer housing with water before starting the motor.
CAUTION