8
050101.06
Connection kit for drinking water tanks
P
MIN. 85 mm (3
3
/
8
˝)
ø 43 mm (1
11
/
16
˝)
ø 43 mm
ø 43 mm
Fitting in sailing boats
When fitting remember that the filler hose must always be posi-
tioned on the same side of the boat as the tank.
This prevents too high a pressure from possibly occurring in the tank
when sailing heeled.
2 2 Fitting the inspection cover and fittings
Position the connector lid preferably where plug P is located
• Use the drill stencil supplied to make the hole for the cover. Finish
the hole free of burrs.
• Drill the three holes (43 mm. diameter) for the fittings. Two holes
on the top for the filler pipe and air-relief pipe, one on the under-
side for the tap water supply.
• Clean the inside of the tank.
• Fit the cover in the tank using the gasket supplied.
• Screw the cover tight against the backing ring using the screws
supplied.
• Assemble the fittings with the gasket rings supplied. Tighten the
nuts using the wrench, never with water-pump pliers. Do not
tighten the nuts excessively.
• Immediately after filling the tank, check that the connector nip-
ples do not leak, tighten the nuts more securely if required. Re-
peat this after 2 days, and again after 4 days.
ø 115 (
11
/
32
”)
ø 6 (
1
/
4
”)
10 (
3
/
8
”)
140 (5
1
/
2
”)
P.C.D
. 136 (5
3
/
8
”)
