Vestil PM5-BR, Инструкция по эксплуатации и обслуживанию

Страница: 3 / 6

Table of Contents Rev. 7/2/2020 PM5-BR MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 3 of 6
ITEM PART NO. DESCRIPTION QTY
1
15-514-136
15-514-137
FRAME WELDMENT (PM5-BR-20-RF)
FRAME WELDMENT (PM5-BR-27-RF)
1
2 33-016-003 MOUNTING BRACKET 2
3 11107
HEX BOLT, GRADE A, ZINC FINISH,
3/8”-16 1 1-1/4”
4
4 33008
FLAT WASHER, LOW CARBON, USS,
ZINC PLATED, 3/8”
8
5 36106
HEX NUT, GRADE A, ZINC PLATED,
3/8”-16
4
6 32416
THREAD CUTTING SCREW,
SLOTTED, TYPE F, ZINC PLATED,
5/16-18 X 3/4
2
ASSEMBLY & INSTALLATION
A. Assemble the back rest
1. Attach a mounting bracket (33-016-003) to one side of the back rest using
3
/
8
” fasteners as shown
in the EXPLODED VIEW (above). Tighten the fasteners.
2. Loosely attach the second mounting bracket to the back rest with fasteners in the uppermost bolt
hole in the bracket. Do not tighten the connection at this time.
B. Mount the back rest on the mounting pins
1. Remove the cotter pins from the mounting pins of your pallet jack. The mounting pins are located
on either side of your pallet jack as shown in the diagram.
2. Slide the bottom holes of the mounting brackets onto the mounting pins. Reinstall the cotter pins
(removed in step B1).
3. Finish attaching the second mounting bracket to the back rest (see step A2). Install the second
set of fasteners through the middle hole of the second bracket. Tighten all fasteners.
EXPLODED VIEW AND BILL OF MATERIALS
Mounting
pin
Mounting bracket
Install remaining
fasteners