background image

 

rev. 3/24/2014 

   LOW, manual.doc 

Copyright 2014 Vestil Manufacturing Corp.                                                                                          1 of 10 

 
 
 
 
 

  

 

 

 

 
 
 
 
 

LOW-S

ERIES 

L

OW 

P

ROFILE 

M

ANUAL 

C

HAIN 

B

LOCKS

 

I

NSTRUCTION 

M

ANUAL

 

 
 

 

 
 
 
 
 

After delivery, immediately remove the packaging from the product in a manner that preserves the 
packaging and maintains the orientation of the product in the packaging; then inspect the product closely to 
determine whether it sustained damage during transport. 

If damage is discovered during the inspection, 

immediately record a complete description of the damage on the bill of lading

. If the product is 

undamaged, discard the packaging.

 

 

NOTES:

 

1) Compliance with laws, regulations, codes, and non-voluntary standards enforced in the location where the 
product is 

used

 is exclusively the responsibility of the owner/end-user. 

 

2) Vestil is 

not liable

 for any injury or property damage that occurs as a consequence of failing to apply 

either: a) the instructions in this manual; or b) information provided on labels affixed to the product. Neither 
is Vestil responsible for 

any

 consequential damages sustained as a result of failing to exercise sound 

judgment while assembling, installing, using or maintaining this product.  

 
 
 
 
 
 
 
 
 
 
 

Vestil Manufacturing Co. 

2999 North Wayne Street, P.O. Box 507, Angola, IN 46703 
Telephone: (260) 665-7586  -or-  Toll Free (800) 348-0868 
Fax: (260) 665-1339

 

www.vestilmfg.com

    e-mail: 

[email protected]

 

 

Table of Contents 

Product Features………………………………………..………………………………………………………… 2 
Hazard Identification: Explanation of Signal Words….……………………………………………………….. 2  
Safety Guidelines…………………………………………………………………………..……………………… 3 
FIG. 1: Trolley assembly and bill of materials………………………………………………………………….. 4 
Installation………………………………………………………………………………………………………….. 5 – 6  
Use Instructions……………………………………………………………………………………………………. 7 
Inspections & Maintenance………………………………………………………………………………………. 7 – 8   
Label Placement Diagram……...………………………………………………………………………………… 9 
Limited Warranty…...……………………………………………………………………………………………… 10 

Содержание LOW Series











Отзывы: