background image

The lightning flash with arrowhead symbol

within an equilateral

triangle

is intended

to alert the user to the presence of uninsulated

dangerous voltage

within the product's

enclosure that may be of sufficient magnitude to consitute a risk of electric shock to
persons

The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance

servicing

instructions in the

literature accompanying the appliance

T0 REDUCE THE RISK 0F FIRE 0R ELECTRlC SHOCK

DO NOT EXPOSE

THIS APPLIANCE T0 RAIN 0R M0ISTURE

WARNING

CAUTION

TO PREVENT ELECTRIC SHOCK,MATCH BLADE OF PLUG TO WIDE SLOT

FULLY INSERT

ATTENTION

P0UR EVITER LES CH0CS ELECTRIQUES

INTRODUIRE LA LAME LA PLUS LARGE DE LA

FICHE DANS LA BORNE CORRESP0NDANTE DE LA PRISE ET P0USSER JUSQU AU F0ND

CAUTION

RISK OF ELECTRIC SHOCK DO NOT OPEN

CAUTl0N

TO REDUCE THE RlSK OF ELECTRlC SHOCK

DO NOT REMOVE COVER

OR BACK

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVlCING T0 QUALIFIED SERVlCE PERSONNEL

1. Read all the instructions before using the product.
2. Do not use this product near water - for example, near a

bathtub, washbowl, kitchen sink, in a wet basemant, or near a
swimming pool, or the like.

3. This product should be used only with a cart or stand that is

recommended by the manufacturer.

4. This product, either alone or in combination with an amplifier

and hrsdphones or speakers, may be capable of producing
sound levels that could cause permanent hearing loss. Do not
operate for a long period of time at a high volume level or at a
level that is uncomfortable. If you should consult an
audiologist.

5. The product should be location or position dose not interfere

with its proper ventilation.

6. The product should be located away from heat sources such as

radiators, heat registers, or other products that produce heat.

7. The product should be connected to a power supply only of the

type described in operating instructions or as marked on the
product.

8. The power - supply cord of the product should be unplugged

from the outlet when left unused for a long period of time.

9. Care should be taken so that objects do not fall and liquids are

not spilled into the enclosure through openings.

10. The product should be services by qualified service personnel

when ;

A. The power - supply cord or the plug has been damaged ;
B. Objects have fallen, or liquid has been spilled into the

product ; or

C. The product has been exposed to rain ; or
D. The product does not appear to operate normally or

exhibits a marked change in perfromance ; or

E. The product has been dropped, or the enclosure damaged.

11. Do not attempt to service the product beyond that described in

the use - maintenance instructions. All other servicing should
be referred to qualified service personnel.

I M P O R T A N T   S A F E T Y   I N S T R U C T I O N S

S A V E   T H E S E   I N S T R U T I O N S

WARNING : 

When using electric products, basic precautlons nhould always be
followed, including the following :

Содержание Mixing Controller









Отзывы: