Vessel IPC20-E, Инструкция по эксплуатации

Страница: 51 / 64

23
„ Operation
Stop
(1) Pressing the power ON/OFF switch once during operation stops the supply of electricity and stops
operation. In addition, turning off the main unit power also turns off the static eraser at the same
time.
Blow volume adjustment
Turning the blow volume control to the left lowers
the blow volume. Turning it to the right increases the blow
volume. Use the included screwdriver to make the
adjustments.
CAUTION
Remember
The control adjustment rotation range is about 270°. Do not use excessive force
when using the screwdriver to turn it. Using excessive force could break the
control.
“NEEDLE CLEAN “Warning Lamp”
Operation Lamp blinks every 100-hour use for IMMEDIATE CLEANING, periodical cleaning of needle
every 100-hour operation. (See Page.
32)
*Ionizing operation can be continued during the blinking.
*After the cleaning, please keep pressing ON/ OFF switch for more than 3 seconds, then resetting the
accumulative operation hours recorded and no blinking. (Accumulative running hours won’t be faded
nor resetting even if power supply suspended.)
Warning Indicator
(1) Abnormal high voltage warning indicator: This illuminates when the high-voltage output is
abnormal.
(2) Fan lock warning indicator: This illuminates when the fan motor stops turning.
When a warning indicator illuminates, unplug the product and check the following points.
(1) Is foreign matter adhered close to the discharge needle?
Æ Refer to maintenance for the “Static Eraser” item under “Maintenance.”
(2) Is foreign matter caught in the fan motor?
Æ After removing the cause, turn on the power again, and check if the warning indicator has
turned off.
*If the warning indicator illuminates again, have the unit repaired by the product was purchased.
*If the warning indicator has turned on, the static eraser’s power ON/OFF switch will not operate. Turn
the No. IPC20-E’s operation switch to stop (
〇
) and wait about 5 sec before turning it on again.