20
■
Installation
2) Mounting the spring of the tip arm
- When purchased, the spring of the tip arm is not
mounted on the one side. As shown in the figure on the
right, insert the spring shaft into the hole and tighten
with a lock nut. At this time, mounting is easier if you lift
the tip arm above while working.
- There are two mount holes, but only use the mount hole
on the intermediate bracket side.
*Caution: Hang the spring hook correctly, (refer to the right fig.)
*Engage the hook into the groove of the plastic part.
*If used for a long time with the spring mounted incorrectly, it
may significantly shorten the durability life of the spring.
*Caution:
Tighten firmly to reach the nylon lock part, to prevent the nut
from loosening.
*Caution:
Do not place your fingers or hands close to the rotating
parts and moving parts.
３
) Mounting the Tool
Tools with their diameters from 35mm to 45mm can be mounted.
①
Take out the rubber plates (large and small) and the
hose band, and loosen the hose band to release.
②
Check the direction of the tool to be mounted, and
wrap the rubber plates around the tool.
- Make the side with the large rubber plate
attached face of the V-shaped part.
- Wrapping the large and small rubber plates
tightly with plastic tape would facilitate the
fitting.
Wrap the rubber plate
around the tool
Temporarily
hold with
plastic tape
①
Lift the arm
②
Insert spring shaft
