Vessel GT-1600VP, Инструкция по эксплуатации

Страница: 9 / 40

How to use
8
・ For operating the tool, make sure to follow the procedures described
in this instruction manual.
・ Do not use the tool:
* if the socket/bit is not properly mounted or not compatible in size.
* if the work environment does not allow you to keep a stable posture,
secure a firm grip on the tool or to operate the tool properly.
* if the floor is slippery or not level.
* if it is used for other purposes than tightening or loosening screws.
* if it has been modified or has any parts missing or lost.
* if the input air pressure is higher than the specified value.
* if more than the specified working torque is required.
・
When the tool is not in use or left unattended, shut off the air supply
and detach the air hose from it.
Preparations before use
●
Check the air pressure
The specified air pressure for this air tool is 0.6 MPa. Do not apply air
pressure outside this specified range as it influences performance,
lifespan and safety.
●
Remove the drain
When moisture or impurities like rust in the pipe get into the mechanism,
it may cause malfunction. Remove accumulated drain in the compressor
before use. To secure dry air supply, install an air filter in order to prevent
moisture and any impurities.
● Use an appropriate air hoses
Please refer to Specifications for choosing an air hose of the appropriate
size for the applied air supply. If the internal diameter of the air hose is
too small, sufficient power may not be obtained as air pressure cannot
increase efficiently. It also happens when the hose is too long.
●
Install the plug
Use a spanner of No.19 to hold Air Inlet Bushing
and fasten the plug.