Vessel GT-1600VP, Инструкция по эксплуатации

Страница: 10 / 40

How to use
9
●
Air coupling
When using the air coupling included in the package, purchase a
compatible connector. When connecting a hose directly to this product,
purchase a hose connection coupling. In both cases, check the size of
the connected hoses.
●
Before the first operation after purchase
When this air tool has been newly installed or the air hose has been
replaced, blow and clean the inside of the hose and piping. Then, idle the
device for a few seconds because lubricant within the mechanism has to
be blasted out with exhaust air.
●
Lubrication
Lubricate the unit regularly for smooth operation of the motor part and to
remove impurities. If you install a lubricator, it will lubricate the tool
automatically. Or, you can lubricate manually from the air supply port
before or after use. (ISO VG10 or equivalent hydraulic oil.)
●
Idle the unit after lubrication
Please idle the unit for several seconds after lubrication has been
conducted because oil will be discharged with exhaust air. Do not idle
the unit while a tip tool is attached.
● Tool tips (sockets / bits / extension bars, etc.)
Do not install a tip for hand tools. There will be a risk of accident as the tip
may be destroyed. Be sure to use a tip for power tools.
●
Tightening bolts/nuts
To tighten bolts/nuts, first tighten bolts/nuts by hand for a couple of thread
pitches. After tightening is complete, immediately release the lever and
stop the tool. Excessive tightening will cause bolts to be broken and life
of the hammer parts to wear/tear quickly.
● When bolts/nuts cannot be loosened
In case bolts/nuts cannot be loosened or tightened as required, please
adopt an impact wrench with a higher capacity.
●
Keep the tool away from organic solvents
Be aware that dipping the tool in the organic solvents will deform the tool.
● In cold areas
Moisture inside the tool may freeze in winter. Be sure to lubricate the tool
to remove the moisture after use.