Vertiv XTE PTS Series, Описание и руководство по установке

Страница: 20 / 24

Vertiv™ XTE PTS Series PEIL/PESB Power Transfer Switches Description & Installation Manual
14
CAUTION! Make sure that the cabinet is supported by the lifting equipment during the installation.
11.
Using appropriate lifting equipment and following all local safety procedures, lift the cabinet and bracket into mounting
position on the pole.
12.
Level the cabinet before tightening the bolts, then tighten the bolts to secure the bracket and cabinet to the pole.
13.
Remove the open bottom from the cabinet, and set the hardware aside.
14.
Install the solid bottom from the pole-mount kit using the hardware saved in the step above.
8 Mounting the Cabinet on a Wall
DANGER! ELECTRICAL HAZARD
Do not install the cabinet during a thunder storm. All power must be turned off before removing inner barrier panels.
8.1 Solid Bottom
A wall-mounted cabinet should have a solid bottom, rather than the open bottom supplied with pad-mounted cabinets. If the cabinet
does not have the solid bottom, order the solid bottom, and replace the standard open bottom with the solid bottom using the
hardware provided.
8.2 Wall Installation
Perform the following steps to install a XTE PTS Series PEIL/PESB Power Transfer Switch on a wall:
1.
Unpack the cabinet.
2.
Verify that the loose parts kit contains the following components:
- two 1/2-inch (1.3 cm) sealing washers, and
- two flat washers.
NOTE!
Mounting hardware is not provided. You must supply two 1/2-inch (1.27 cm).
3.
Remove the four 1/2-inch (1.3 cm) knockouts from the back of the cabinet. (See Figure 9 .)
CAUTION! Make sure that the cabinet is supported by the lifting equipment during the installation.
4.
Use appropriate lifting equipment to raise the cabinet into the mounting position on the wall, and keep it supported.
5.
Use the cabinet as a template to drill four mounting holes. (See Figure 9 ).
6.
If anchors are being used, remove the cabinet, and install the anchors.
7.
Slide the two sealing washers onto the two top bolts, with the metal facing toward the head of the 1/2-inch (1.3 cm) bolt. (See
Figure 9 ).
8.
Install the two flat washers onto the two bottom bolts.
9.
Install a bolt with its washer into each of the four 1/2-inch (1.3 cm) knockout holes in the cabinet, then into the wall or other
mounting structure. (See
Figure 9 ).