Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 31 / 102

Figure 4.15 Panel and Gasket placement—two PDX/PCW units (20-kW (N + 1)/36-kW
(N)) Configuration
NO. DESCRIPTION NO. DESCRIPTION
1 Solid split-side panel 5 PDX/PCW, Control Panel and Fire-suppression System
2 Cable-pass-through split-side panel 6 Gasket, factory-installed around each base plenum
3 Cable-pass-through split-side panels on both sides of rack 7 PDX/PCW and Control-panel shell
4 Gasket, field-installed
To install the racks:
1. Find the DCR rack that has the two solid split-side panels on one side and cable-pass-through
panels on the other to place next to the PDX/PCW and Control Panel/Fire-suppression System
(shown in Figure 4.14 on the previous page or Figure 4.15 above).
2. Apply the supplied gasketing to the rack's frame profile edge as shown Figure 4.16 on the next
page:
• Start the gasket strip at the base of the rack, directly in the middle of the rack.
• Using pressure to make sure it adheres to the frame, apply the gasket continuously
following the profile edge of the rack’s frame.
• At each corner, make a 1-in. to 1.5-in. radius.
• Create a sealed joint by butting the start and finish edges together.
NOTE: Tags have been provided in each rack that illustrate these instructions as well. Do not remove
these tags until the SmartRow assembly is completed.
Vertiv | SmartRow DCR Installer/User Guide | 31