Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 32 / 102

Figure 4.16 Applying gasket to profile edge on side of the rack
NO. DESCRIPTION
1 Gasket 1-in. to 1.5-in. corner radius
2 Gasket start and finish
3. Use an adequate number of personnel to install that rack on the Base Plenum that is adjacent
to the Liebert PDX/PCW and DCR Control Panel & Fire Suppression System.
NOTE: The side panels are interchangeable among the racks. Make sure that the rack that will be next
to the PDX/PCW and Control Panel has the solid split-side panels on one side, as described in step 1.
NOTE: Removing the rack’s front and rear doors will lighten the unit, making it easier to maneuver.
• When setting DCR Racks on the base plenum, be sure to:
a. Align the front frame of the rack to the control-panel frame.
b. Space the DCR Racks evenly and square with the side of each DCR Base Plenum-
Rack.
NOTE: Take care not to damage the gasket when applying it and when setting the DCR Racks on the
base plenum. If the gasket is damaged, the rack must be removed and the gasket replaced. A damaged
gasket will permit cooling air to escape, which will reduce cooling efficiency, increase energy use and
adversely affect fire-suppression system operation.
4. Repeat steps 2 and 3 for each rack with cable-pass-through split-side panels on both sides of
the rack (Figure 4.14 on page 30 or Figure 4.15 on the previous page).
5. Repeat steps 2 and3 for the rack with left-side solid split-side panels (Figure 4.14 on page 30
or Figure 4.15 on the previous page).
6. Bay each adjacent rack with supplied baying plate and hardware, (2) plates front and back.
Vertiv | SmartRow DCR Installer/User Guide | 32