Vertiv Liebert XDH, Руководство пользователя

Страница: 42 / 84

Vertiv | Liebert XDH | User Manual 32
Electrical Installation
4.2.2.Connecting the Power Cable of the XDH Unit
Figure 4-1 shows the position of the power port of the XDH unit. L, N, and PE are connected to the
corresponding ends of the external power supply. Reserve a certain margin at the inlet cable and fix it on the
cable clamp then fix the cable on the unit’s inner board. To understand the location of the top inlet/ outlet hole
and bottom inlet/ outlet hole properly see Figure 3-6 & Figure 3-7 in Chapter 3. Table 4-1 describes the rated
full-load current value (FLA) of the unit.
Table 4-1 Full-load Current Values (unit: A)
Model Full Load Amp (A)
XDH030BS1LH0
8
XDH030BS15R1
• The cable sizes should meet the local wiring regulations.
4.2.3.Connecting Control Cables
The field connection terminals are located as shown in Figure 4-1 , and the enlarge view of the connection
terminal is shown in Figure 4-3 . Figure 4-2 shows the connection layout of XDP and XDH
Figure 4-2 Layout of XDP and XDH