To set the date and time:
1.
From the side navigation bar of the
System
tab, click
Network
.
2.
Under the SNTP heading, select
NTP Server
to use an NTP server.
-or-
Select
Local
to manually set the date and time.
3.
If using NTP, enter an NTP server site in the Time Server field.
4. Select either
Hourly
or
Daily
for the synchronize rate.
5.
Use the drop-down menu to select the time zone.
6. If manually setting the date and time, enter the time in YYYY-MM-DD HH:MM:SS format in the System Date
and Time field.
7.
Click the Save icon.
NOTE: To re-sync the time immediately, click the
Sync Time Now
icon at the top of the window.
NOTE: The date and time must be entered manually after every reboot or power cycle for MPX and MPH model PDUs
with an RPC2 module installed and Local mode enabled.
Notification
The RPC2 communications module generates notifications for a wide variety of events. It can be configured to direct or
store those event notifications for immediate use or for analysis later.
To configure notifications:
1.
From the side navigation bar of the
System
tab, click
Notification
.
2.
For each notification type, check the boxes next to the type of notification to be sent.
-or-
Check the box next to the heading to select that type of notification for all events in the list: e-mail, SMS, SNMP
Trap or SysLog notifications.
3.
Click the Save icon.
Messaging
An administrator can configure email and SMS settings to be used for notifications from the Messaging window.
To verify the settings once configuration is complete:
1.
From the side navigation bar of the
System
tab, click
Notification - Messaging
.
2.
Check the box next to Email to enable the configuration of email settings.
3.
Enter the sender and recipient's email addresses..
4. Check the radio button to either use the event or to create a custom subject for the email.
5.
Enter the SMTP server and port number.
6. Click the Authentication checkbox to enable the subsequent fields.
7.
Enter a username and then click the Password checkbox to enable the Modify Password field.
8.
Enter a new password in the Modify Password field.
9. Choose the connection type from the drop-down list box.
10. Click the Save icon at the top of the window.
11. To verify the email configuration, click the Verify Email icon in the upper-left of the window.
To configure SMS settings:
1.
From the side navigation bar of the
System
tab, click
Notification - Messaging
.
2.
Check the box next to SMS to enable the configuration of the SMS settings.
Vertiv
| RPC2™ Communications Module Installer/User Guide |
24
Содержание LIEBERT RPC2
Страница 57: ...Vertiv RPC2 Communications Module Installer User Guide 53 ...
Страница 58: ......
