Vertex Wireless VW450, Руководство пользователя

Страница: 11 / 35

11 | p a g e
1.5. Installation of the antenna and location of the equipment for voice service
Before you select a localization to place VW450, you should read the section for their Security in the first part of this
manual. You can place it in a plane area just as the floor, the walls or the desk or table.
1. It connects the antenna at the VW450 (previously it should couple the antenna in their support, make sure of
making the one it couples in a complete way, verify that the antenna mo is slack) and locate her it more far possible
of the terminal. If the antenna is located near the VW450 noise she/he will take place during the communication,
avoid it!
* Notices: make sure of pressing the antenna completely to their connector in the terminal.
2. Using the marked port as “Phone “connects the VW450 to the central PBX, or to the system of tariff of the booth
or a similar telephone. If their Terminal is model VW450 and you will use similar fax, connect the fax machine to the
port “Fax ".
3. Connect the adapter to the Terminal. Use the connector "DC Input."
4. Connect the adapter DC in an appropriate energy plug.
5. Turn on the terminal. Use the switch “On/Off ".
6. Checks the power of the signal GSM, verify the state of the led “Signal“(check the section 2.1). To improve the
signal reception, move the antenna and verify the state of the led “Signal".
Avoids leaving the antenna in a location in which the led illuminates red or be shut down
7. The terminal is ready to be used.
Attention : If the SIM Card (Chip) that will be used in the terminal has the number disabled PIN (it consults to their
operator), it won't be necessary to make some additional configuration in the VW450; this will be ready for their use.
In case, on the contrary, the SIM Card has the active PIN that same number PIN it will be recorded in the terminal. To
make it, connect a telephone similar to the port “Phone” and dial: #* 110 * 2 * number PIN #
With the previous procedure it will be engraving in the terminal the number PIN. It is this way when the terminal is
out and then lit, it won't be necessary to carry out this procedure again. Although the Terminal remains out a lot of
time, without current and without battery, the PIN that was recorded will always remember.