Figure 5
Saddle Valve
7
4.4 Feed Water Connections
To connect the feed water, use the supplied self-piercing saddle valve to con-
nect to the cold water supply line under the sink. Attach the 1/4” tubing to the compres-
sion fitting on the side of the valve. Clamp the saddle valve over the copper or plastic
feed line (cold water only). Turn the handle on the valve until the needle stem pierces
the tube. Then retract the needle 1-2 turns to start water flow. See Figure 5.
4.5 Drain Connection
The black drain line in the back (Fig. 5) must be hooked to the drain line
ahead of the normal sink water trap.
See Figure 6 below. Place the 2 part drain saddle on the drain pipe before the
drain trap. Allow proper space for the drilling operation. Tighten the saddle bolts evenly
on both sides. Using the opening in the drain outlet saddle as a guide, drill a 1/4” hole
in the drain pipe. Clean any debris out of the drain saddle connection. Connect the
drain line to the cooler using the 1/4” black tubing supplied.
Figure 6
Drain Connections for RO filter
