8
VX-820E S
EriES
O
pErating
M
anual
B
EForE
y
ou
B
Egin
Battery Pack Installation and Removal
r
To install the battery, hold the transceiver with
your left hand, so your palm is over the speaker
and your thumb is on the top of the belt clip.
Carefully mate the battery’s four insertion slots
with their corresponding alignment tabs on the
transceiver case, while tilting the Belt Clip out-
ward. Proper alignment occurs with the battery
pack offset about 1.5 cm from the top edge of the
battery compartment.
r
Guide the pack on to the tabs with a slight inward
pressure, then slide the battery pack upward, until
it locks in place with a “
Click
”.
Insert the Battery Pack
Tilt the Belt Clip
r
To remove the battery, turn the radio off and re-
move any protective cases. Slide the Battery Pack
Latch on the bottom of the radio toward the front
panel while sliding the battery down about 1.5
cm. Then lift the battery out from the radio while
unfolding the Belt Clip.
Do not attempt to open any of the recharge-
able Lithium-Ion packs, as they could ex-
plode if accidentally short-circuited
.
Low Battery Indication
As the battery discharges during use, the voltage
gradually becomes lower. When the battery voltage
becomes to low, substitute a freshly charged battery
and recharge the depleted pack. The LED indicator
on the top of the radio will blink red when the battery
voltage is low.
Caution
Danger of explosion if battery is replaced with
an incorrect battery. Replace only with the
same or equivalent type.
Note
The
FBA-34
was designed as a backup bat-
tery pack, and it can be used to power the
transceiver if you are in an area that does not
require the use of an intrinsically safe radio.
Содержание VX-820E Series
Страница 17: ...15 VX 820E Series Operating Manual Note ...