Vertex Standard VX-210AU, Руководство по обслуживанию, Страница: 4 / 42

4
Operating Manual Reprint
r
To stop Dual Watch:
Press the
ACC
button.
Operation will revert to the channel to which the
CH
knob is set.
Talk Around
Press the
ACC
button to activate the Talk Around fea-
ture when you are operating on duplex channel sys-
tems (separate receive and transmit frequencies, uti-
lizing a “repeater” station). The Talk Around feature
allows you to bypass the repeater station and talk di-
rectly to a station that is nearby. This feature has no
effect when you are operating on “Simplex” channels,
where the receive and transmit frequencies are already
the same.
Note that your dealer may have made provision for
“Talk Around” channels by programming “repeater”
and “Talk Around” frequencies on two adjacent chan-
nels. If so, the
ACC
key may be used for one of the
other Pre-Programmed Functions.
Call/Reset
When the 2-tone selective calling unit is installed, press
the
ACC
button to silence the receiver and reset for
another call, when a communication is finished.
Speed Dial
Your Dealer may have pre-programmed Auto-Dial tele-
phone number memories into your radio.
To dial a number, just press the Dealer-assigned
ACC
button for Speed Dialing. The DTMF tones sent dur-
ing the dialing sequence will be heard in the speaker.
TX Save Off
Press the
ACC
button to disable the Transmit Battery
Saver, if you are operating in a location where high
power is almost always needed.
The Transmit Battery Saver helps extend battery life
by reducing transmit power when a very strong signal
from an apparently nearby station is being received.
Under some circumstances, though, your hand-held
radio may not be heard well at the other end of the
communication path, and high power may be neces-
sary at all times.
ACC 1
Activates an optional Unit (module) while the
ACC
button is held depressed.
When you release the
ACC
button, the optional Unit
will be disabled.
For further details, contact your
VERTEX STANDARD
dealer.
ACC 2
Toggles the optional Unit “on” or “off” whenever you
press the
ACC
button.
For example, when the optional “FVP-25” voice en-
cryption unit is installed, press the
ACC
button mo-
mentarily to disable the voice encryption feature tem-
porarily.
Press the
ACC
button again to re-enable the voice en-
cryption feature.
Accessories & Options
FNB-V57
7.2 V 1100 mAh Ni-Cd Battery Pack
FNB-V57IS
7.2 V 1100 mAh Ni-Cd Intrinsically safe Battery
FBA-25
Alkaline Battery Case (6
x
AA)
NC-76B
120 VAC Wall Charger
NC-76C
230-240 VAC Wall Charger
VAC-6400
6-Unit Multi charger
VAC-400B
120 VAC Desktop Rapid Charger
VAC-400C
230-240 VAC Desktop Rapid Charger
VCM-1
Mobile Mounting Bracket for VAC-400
MH-45B4B
Speaker/Microphone
MH-37A4B
Earpiece/Microphone
VC-25
VOX Headset
FVP-25
Encryption /DTMF Page Unit
VTP-50
VX-Trunk Unit
CT-42
PC-Programming Cable (CT-28 + CT-29)
CT-27
Cloning Cable (Set-to-Set Cloning)
FTT-17
16 keypad for VX-Trunk (VTP-50 required)
LCC-210
Leather Case