Vertex Standard FT-2900R, Руководство по настройке

Страница: 4 / 5

FCC ID: K6620393X50
IC: 511B-20393X50
Alignment
Vertex Standard Co.,Ltd. 4
ˆ
Press the [D/MR(MW)] key three times.
ˆ
Press the [D/MR(MW)] key.
S-meter Level (S-9)
ˆ
Inject a 145.100 MHz signal at a level of +23 dBµ (with 1 kHz modulation @±3.5
kHz deviation) from the RF signal generator.
ˆ
Rotate the DIAL knob to set the alignment parameter to “145.100 S9.”
ˆ
Press the [D/MR(MW)] key to enable adjustment of the “S-meter Level (S-9).”
ˆ
Press the [D/MR(MW)] key three times.
ˆ
Press the [D/MR(MW)] key.
TX Power (High)
ˆ
Rotate the DIAL knob to set the alignment parameter to “145.000 HP.”
ˆ
Press the [D/MR(MW)] key to enable adjustment of the “TX Power (High).”
ˆ
Press the PTT switch to activate the transmitter, adjust the DIAL knob so that the
RF Power Meter reading is 75 W (±3.0W).
ˆ
Press the [D/MR(MW)] key.
TX Power (Low 3)
ˆ
Rotate the DIAL knob to set the alignment parameter to “145.000 L3.”
ˆ
Press the [D/MR(MW)] key to enable adjustment of the “TX Power (Low 3).”
ˆ
Press the PTT switch to activate the transmitter, adjust the DIAL knob so that the
RF Power Meter reading is 30 W (±1.5 W).
ˆ
Press the [D/MR(MW)] key.
TX Power (Low 2)
ˆ
Rotate the DIAL knob to set the alignment parameter to “145.000 L2.”
ˆ
Press the [D/MR(MW)] key to enable adjustment of the “TX Power (Low 2).”
ˆ
Press the PTT switch to activate the transmitter, adjust the DIAL knob so that the
RF Power Meter reading is 10 W (±1.0 W).
ˆ
Press the [D/MR(MW)] key.
TX Power (Low 1)
ˆ
Rotate the DIAL knob to set the alignment parameter to “145.000 L1.”
ˆ
Press the [D/MR(MW)] key to enable adjustment of the “TX Power (Low 1).”
ˆ
Press the PTT switch to activate the transmitter, adjust the DIAL knob so that the