12
2
N.B. When the range is not being used, set the gas knobs to their
positions and also close the gas shut-off valve placed on the main gas
supply line.
CAUTION!
The range becomes very hot during operation. Keep children well out of
reach.
LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE
SAFETY DEVICE (Dual burners)
In order to light the burner, you must:
1. Push and turn the knob in an anti-clockwise direction up to the position
(maximum rate of inner + outer crown); push in and hold the knob until the flame has
been lit (fig. 2.4).
The sparks produced by the lighter situated inside the relative burner will light the
flame.
In the event that the local gas supply conditions makes it difficult to light the burner
in position
, try again with the knob in position
.
2. Wait for about ten seconds after the gas burner has been lit before letting go the
knob (safety device activation delay).
3. Adjust the gas valve to the desired position.
If there is no mains electrical supply, the burners can be used with no restriction.
In that case, in order to light the burner, you must:
1. Bring a lighted match close to the burner (as per side figure) and keep it in place until
the burner has been ignited.
2. Push and turn the knob in an anti-clockwise direction up to the position
(maximum rate of inner + outer crown); push in and hold the knob until the flame has
been lit (fig. 2.4).
In the event that the local gas supply conditions makes it difficult to light the burner
in position
, try again with the knob in position
.
3. Wait for about ten seconds after the gas burner has been lit before letting go the
knob (safety device activation delay).
4. Adjust the gas valve to the desired position.
If the burner flame should go out for some reason, the safety valve will automatically stop
the gas flow.
To re-light the burner, return the knob to the closed
position, wait for at least 1
minute and then repeat the lighting procedure.
If your local gas supply makes it difficult to light the burner with the knob set to maximum,
set the knob to minimum and repeat the operation.
