40
20306742
KHLDV Series Gas Fireplace
TOUCH SCREEN REMOTE CONTROL OPERATION
Setting Privacy Code on Transmitter:
Figure 45
The remote transmitter privacy code is preset in factory.
In the event of activation or interference from other near-
by transmissions, change the code using the following
procedures (learn function must be
performed after changing the code):
1. Press the ON/arrow button and
the TIMER button at the same
time to enter privacy code setup
mode.
2. The setup display is shown in the
fi
gure. The four digits on the top
stand for the privacy code (as the
actual DIP switches on Ambient’s
previous remotes). The default
values of the four digits will be all
“1” (ON).
3. The
fi
rst digit will be
fl
ashing upon entering the setup
mode. Push the ON button to toggle its value between
“0” (OFF) and “1”(ON), and push the “OFF” button
to jump to the next digit. The next digit will then start
fl
ashing and the
fi
rst one stops
fl
ashing. Set up the
four digits to your choice.
4. After setting up all the four digits, push “OFF” to
fi
nish
the process and return to the previous mode.
5. The Signature Command control board then needs to
re-learn the new setting.
Performing Learn Function
1. The RF receiver button on the control board in the
fi
re-
place must be in the on position before the learn func-
tion can begin.
Figure 46.
With the Command Center
master switch in the
ON position, use paper
clip to depress the re-
cessed button on Con-
trol Board, one beep for
RF receiver ON or two
beeps for RF receiver
OFF
2. Holding the OFF button
on the Command Cen-
ter while turning on the
master switch will acti-
vate the learn function
for the transmitter.
3. After the above opera-
tion, two beeps will be given and the green LED on the
Command Center will
fl
ash for 10 seconds.
4. During the 10 seconds, press the OFF button on the
transmitter to learn. Another two beeps will be given to
con
fi
rm a successful learning.
Figure 47
Figure 45
Battery Door
Master Switch
ON
LED
OFF
FP2650
Command Center
Figure 47
W
ARNING
Do not use two (2) or more remote control sys-
tems in the same area with the same privacy
code setting, as they will communicate with
each other. This may cause the appliances to
malfunction.
Resetting the transmitter:
If the transmitter is not working properly, reinstall the bat-
teries to reset the transmitter.
1. Pull out at least one of the batteries.
2. Press any key on the screen to discharge.
3. Wait for 10 seconds and reinstall the batteries.
Pushing and holding any key for more than 10 seconds
until the display refreshes will also reset the transmitter.
FUNCTIONS AND OPERATIONS
General:
The TSFRSC Remote Control has four (4) operating
modes: Manual, Timer, Thermostatic and Smart Mode
®
Thermostat. The control system can be set to tempera-
ture range between 45° F and 90° F. The blower speed
and
fl
ame height can be adjusted in the manual, timer
and thermostatic mode. The Smart Mode
®
thermostat
will automatically adjust
fl
ame height and blower speed
according to the difference between Set and Room tem-
peratures.
The transmitter will operate the remote receiver from 1
foot to a maximum of 30 feet. The distance is reduced
when batteries are low.
Manual Mode
Figure 48
In this mode, the TIMER button and the THERMO but-
ton will only display “TIMER” and “THERMO”, respec-
tively without showing the time and the SET temperature.
Pressing the ON/up and OFF/down buttons will change
RF Receiver
ON/OFF
Control Board
Figure 46
Front Panel Bezel
Optional