4. Remove the rear shroud held by two Phillips round head machine screw in the center and four sheet metal
screws - two on each side. This allows access to the six hex head nuts and washers holding the damper housing
assembly and the fireback retainers.
FIG. 6 Left damper housing showing one bolt removed
FIG. 7 Right fireback bracket removal
7. Slide the fireback brick forward and out of the unit.
8. Slide the fountain assembly out.
9.
This completes the disassembly.
5. Remove the damper housing assembly. First remove the damper handle with the Allen key supplied with the
unit (FIG. 5). Locate and remove the four hex head through bolts, two per side on the outside of the inner back,
that hold the upper fireback in place (FIG. 6). The nuts and washers are on the outside of the back. This may
require the use of two 7/16" wrenches. Gently rotate the damper housing down right side first and maneuver out
of the firebox by sliding left to right to clear the damper rod from the left side. Please locate damper rod spacer
and remove from the hole in the side for reinstalling. Ensure damper rod washer is in place near the end (FIG.
8). This prevents the rod from sliding out of position when re-installed.
6. Remove the fireback. Locate the two hex
nuts on the outside of the inner back that hold
the lower refractory brackets in place (FIG. 7).
The nuts and washers are on the outside of
the back. This may require the use of two
7/16" wrenches. Remove the two hex nuts
with washers and pull out the hex head cap
screws holding the brackets. This may require
the use of two 7/16" wrenches. Remove the
brackets. Hold the top of the fireback while
removing the brackets as it will fall forward with
the brackets removed.
FIG.5 Remove damper handle
Содержание Defiant 1610
Страница 1: ...SERVICE MANUAL...
Страница 7: ...FIG 15 Damper housing assembly shown rear view...