Vermont Castings • Dauntless FlexBurn Installation Manual_R8 • 2020 - ___ • 11/21
19
3-90-586000i
Figure 5.4
- Assemble the fall away door handle.
Storing the Handle
Use the removable handle to open or close the doors. After
using it, remove the handle so it will not get hot. Store the
handle in the handle holder installed behind the left front
leg, Figure 5.5.
Figure 5.5
- Handle holder and heat shield positions.
Handle
Handle Holder
C. Smoke and CO Detectors & Safety Tips
Smoke and CO Detectors
The use of smoke and carbon monoxide (CO) detectors
throughout the home is strongly advised, even if not
required by building codes or insurance regulations.
It is a good idea to install a smoke detector in the living
areas and each bedroom. Follow the smoke/CO detector
manufactures placement and installation instructions and
maintain regularly.
You may not, however, wish to install a detector in the
immediate vicinity of the stove. Depending on the sensitivity
of the unit, the alarm can be set off while you are tending
the fire or emptying the ashes. If you install a detector in the
same room, locate it as far away from the stove as possible.
Safety Tips
Conveniently locate a “Class A” fire extinguisher to contend
with small fires. Be sure the fire extinguisher works and
is clearly visible. All occupants of the house should know
where it is, and how it operates. Have heavy stove gloves
available near the stove. Have special safety accessories
(e.g., Child Guard Screen) available for use if small children
will be in the home.
Fire Risk
• Do not leave the fire unattended when the
door is unlatched.
• Unstable firewood could fall out of the firebox
creating a fire hazard to your home.
WARNING
!
In the event of a stove pipe or chimney fire….
• Evacuate the house immediately
• Notify the fire department
• If the fire isn’t too threatening, closing down the stove
tight, (damper, primary air, all doors) will help to smother
the fire.
• Inspect your stove, vent pipe and chimney for any
damage caused by the fire and correct any damage
before using your stove again.
D. Reverse the Flue Collar
(If necessary)
Tools Required:
Phillips head screwdriver.
The flue collar is reversible for either a top or rear venting
installation. The appliance is shipped with the flue collar in
the top vent position.
Converting Collar For Rear Vent Installation
1. Remove (10) #8 Tek screws from the heat shield cover and
heat shield. Remove heat shield and cover, Figure 5.6.
2. Remove (2) 1/4-20 pan head screws from the flue collar.
Remove flue collar, Figure 5.6.
3. Turn flue collar to horizontal position. Inspect rope gasket
located on the rear cast housing to ensure a leak free seal.
Re-install flue collar, heat shield and heat shield cover,
Figure 5.7.
Note:
There is a knockout on the rear air jacket that will need to
be removed prior to installing the flue collar for it to fit properly
to the unit, Figure 5.11.
Figure 5.6
Flue Collar
Top Heat Shield Cover
Heat Shield