Sportrider
2013-02
Page 11
To reassemble, please proceed as follows:
•
Put the batteries back in and connect to
the battery plugs (plugs of the same color
go together).
•
Use the straps to tighten the batteries in
such a way that they will not move, even
during drives.
•
Mount the rear plastic cover.
•
Mount the seat (see "Adjusting the seat"
chapter).
2.4 Operating the brakes
To apply the electromagnetic brakes:
1. Let go of the speed or drive lever, the electromagnetic brake in the motor will be activated, the
scooter will stop. After stopping, turn the key to OFF and remove the key. The lights will go out
and the electromagnetic brake is engaged (locked).
To apply the manual brake:
1. Pull the brake lever
towards the handgrips.
2. Release the brake lever
.
Lock the hand brake lever by pushing on the lock
button
while squeezing the manual brake. To
release the manual brake, squeeze the lever again
gently, the lock button
is released and you can
slowly release the brake lever.
The manual brake tightness can be adjusted by the
brake cable adjuster
.
If for any reason the scooter does not stop when you release the operating lever, immediately use the
manual brake to stop the scooter and turn the key to "OFF".
2.5 Transfer in and out the scooter
1. Park the scooter as close as possible to the place where you
want to transfer.
2. Check that the scooter is switched off.
3. Put the arm support on the side you want to transfer upwards.
4. Transfer to / from the seat of the scooter.
2.6 Correct position in the scooter
Some recommendations for a comfortable use of the scooter:
1. Position your backside as close as possible to the back rest.
2. Make sure your upper legs are horizontal.
1
2
3