Inovys II
2011-11
Page 16
EN
NL
L
WARNING:
Risk of tipping over – Be aware that you change the stability of the
wheelchair when changing the position of the driving wheels.
L
WARNING:
Risk of injury – Make sure that the rear wheels on both sides are
mounted in the same position.
DRIVING WHEELS
Four possible wheel sockets are provided in a
swage block of the frame for the use of driving
wheels (24”)
Ⓐ,
(22")
Ⓑ
. Depending on which
suspensions are used to attach the driving
wheels, the wheel position (stability or
manoeuvrability of wheelchair: 45 mm) and the
seat height can be changed. The wheel sockets
attached in the delivery condition can be attached
in all sockets (bore holing)
The wheel sockets in the frame tubing
Ⓒ
serve only to attach 16” wheels (transit version). The
stability or manoeuvrability of the wheelchair can be adjusted over 50 mm.
STEERING WHEELS
In the standard model, the INOVYS II is delivered with two 8” steering wheels (200 mm x 50
mm or 200 mm x 35 mm).
3.5 Adjust the seat depth
L
WARNING:
Risk of injury – Make sure that all screws are secure and properly
tightened.
The seat depth can be adjusted in 3 positions (steps 20 mm). Adjust the seat depth
according following rules:
Seat depth
Hole
480 mm
500 mm
520 mm
Table 3: Seat depth
1. Loosen the screws
Ⓐ
beneath the
front seat frame.
2. Pull or push the front of the seat frame into
the desired position.
3. Retighten the screws
Ⓐ
firmly again.
Note: When rebuilding the seat depth in the back frame area, the displacement of the spring
for adjusting the back is changed and a gap can occur between the back and seat cushions.