Vermeiren Ceres 3, Инструкция по эксплуатации

Страница: 13 / 172

Ceres 3 Deluxe, Ceres 4 Deluxe
2015-06
Page 11
To reassemble, please proceed as follows:

Insert the supports of the front

and rear

frames into each
other in such a way that the
holes for the safety pins

are
aligned.

Push the safety pins

into the
support holes as far as they
can.

Reconnect the plugs linking the front and
rear parts of the frame (plugs of the same
color go together).

Put the batteries back in and connect to
the battery plugs (plugs of the same color
go together).

Use the straps to tighten the batteries in
such a way that they will not move, even
during drives.

Mount the rear plastic cover.

Mount the seat (see "Adjusting the seat" chapter) and the armrests (see "Mounting or removing of
armrests" chapter).
2.4 Operating the brakes
To apply the brakes:
1. Let go of the speed or drive lever to stop the scooter.
2.5 Mounting or removing of armrests
L
CAUTION:
Risk of clamping – Keep fingers, buckles and clothes away from the
attachment point (on the tube of the seat frame) of the armrest.
To mount the armrest on the scooter:
1. Slide the tube of the armrest in the tube of the seat frame.
2. Push on the tube of the armrest until the desired seat width.
3. Mount the star knob on the back of the scooter.
The armrest of the scooter can be taken off.
1. Remove the star knob on the back of the scooter.
2. Pull on the tube of the armrest.
3. Slide until the tube comes out the tube of the seat frame.
2.6 Transfer in and out the scooter
1. Park the scooter as close as possible to the place where you
want to transfer.
2. Check that the operator control is switch off.
3. Put the armrest on the side you want to transfer upwards.
4. Transfer to / from the seat of the scooter.
1
2
3
1 = Rear frame
2 = Front frame
3 = Safety pin