WHAT NOT TO DO
•
Never connect a STAGEMAKER controller to a power source other than specified on the unit.
•
Do not set down the controller without having an adapted support, to avoid damaging the components on
the rear
•
Never modify the controller unless the constructor has studied and authorised the modification.
•
Never modify the values and adjustments of the safety components, outside the limits provided for in the
manual, or without the approval of the constructor.
•
Never try to repair or intervene on the controller without the authorisation of the constructor or a qualified
electrician.
•
Do not let an unqualified person use the controller.
•
Never connect more hoists than the available number of outlets (channels) or number of selector switches
available.
•
Do not use additional splitters to connect more than one hoist per channel.
•
Avoid shocks or accidental collision with other objects.
•
Never open the controller as long as the system is under power.
•
Never block, or lock the RUN button in order to continue a movement without manual interference.
•
Do not operate the controller if your physical condition does not allow it.
•
Never use the controller if it is in bad condition.
•
Never use suspected spare parts or parts whose origin is not known.
•
Do not subject the controller to brutal shocks.
•
Never distract the operator’s attention while he is being operating the system.
•
Do not use the controller for a purpose or in an area for which it is not intended.
•
Do not expose the controller to an aggressive atmosphere
(temperature, acidity... )
•
Do not use the safety components as operation components
(emergency button, main fuse switch. etc..)
•
Do not use the controls needlessly (avoid inching - stop-start operation of the buttons). This can cause
overheating and even damage to the hoist.
•
Do not change the hoisting direction whilst the RUIN button is pressed (hoist under power)
•
If hoist direction doesn’t match with the indications on the controller, don’t change phases inside the
controller but exchange two phases on the hoist motor or the interconnecting cables.
•
Never use hoists who are running in the opposite direction of the selected motion.
•
Do not connect the controller to an unknown power supply, check if power source matches the specification
of the controller and the hoists.
(under voltage or over v/- 5%, absence of phase etc...).
2004.07 GB
