VERITAS MyJanis, Быстрая инструкция

Страница: 19 / 40

19
Threading the upper thread
Please note:
It is important to carry out the threading correctly otherwise sewing problems may result.
1
Raise the needle to its highest positi-
on by turning the handwheel towards
you (counterclockwise) so that the
mark on the handwheel points
directly up. Raise the presser foot to
release the tension discs.
(1) Mark on handwheel
1
Place the thread and spool holder
onto the spool pin.
2
3
4
5
6 7
8
Guide the thread around the thread
guide as illustrated.
Thread the tension module by pas-
sing the thread between the silver
discs.
Then, down and around the check
spring holder.
At the top of this movement pass the
thread from right to left through the
slotted eye of the take-up lever and
then downwards again.
Now pass the thread behind the thin
wire needle clamp guide. Pull the
end of the thread through the needle
from front to rear and pull out about
10 cm of thread. Use the needle
threader to thread the needle.
Draw the thread from the spool
through the upper thread guide.
EN