OPERATION
Installation Instructions
H-6001
KW/KWH Transducer
Easy installation
■
Small size (9.50" X 8.25" x 4.0") fits directly in
most panel enclosures.
■
Conduit ready enclosure for external mounting.
Hinged panel door
■
Direct voltage connection up to 600 VAC--no
expensive potential transformers (PTs)
■
Powered by voltage inputs
■
Easy field voltage selection (120 to 600 VAC)
■
4-20 mA output loop continuity LED
■
Pulse output rate LED
Accurate analog and pulse outputs
■
Accurate to +/- 0.5% of reading..true
RMS power!
■
4-20 mA output for demand KW
■
Pulse output for KWH...adjustable rate
compatible with all automation systems and
data loggers
■
Phase loss/reversal/low voltage alarm output to
protect valuable equipment
■
KW and/or KWH display options. Maintains
readings in event of power loss
SAFE CTs...eliminates need for costly CT
shorting bars
■
Current transformers (CTs) utilize accurate
1.0 V output...non hazardous, even if left
unshorted!
■
Eliminates need for current shorting bars
■
Choose from split-core or solid-core CTs
■
CT accuracy
±
1% from 1% to 100% of the
rating
The H-6001 series 3-phase Power (KW) transducer is de-
signed for use in industrial, commercial, and building
automation KW and KWH applications.
The H-6001 accepts three Veris 1.0 V current transformer
inputs and three direct connect voltage inputs. The trans-
ducer multiplies the input current signal, voltage input,
and power factor for each phase to calculate true RMS
power (KW = E x I x 1.73 x power factor). The instantaneous
power (KW) of all three phases is summed and converted
to an industry-standard 4-20 mA output signal for use in
demand management (load shedding) applications. The
sensor also accumulates this instantaneous value over
time and produces a pulsed output proportional to the
energy usage (KWH). The frequency of the output pulses
is proportional to the total power consumed and can be
used to measure energy usage for an entire building,
selected area, or individual loads (chillers, compressors,
etc..).
WARNING--REFER SERVICING TO
QUALIFIED PERSONNEL ONLY!
!
• This product is not intended for life or safety
applications
• Potential electrocution hazard exists. Installing
sensors in an energized motor control center or
on any energized conductor can be hazardous.
• Read instructions thoroughly prior to install
Severe injury or death can result from electrical shock
during contact with high voltage conductors or related
equipment. Disconnect and lock-out all power sources
during installation and service. Applications shown
are suggested means of installing sensors, but it is the
responsibility of the installer to ensure that the instal-
lation is in compliance with all national and local
codes. Installation should be attempted only by indi-
viduals familiar with codes, standards, and proper
safety procedures for high-voltage installations.
Literature #L10159-1196
10831 S.W. CASCADE BLVD.
PORTLAND, OREGON 97223
(503) 598-4564 FAX (503) 598-4664
1-800-354-8556
VERIS INDUSTRIES, INC.
http://www.veris.com email:[email protected]
®
