Z204455-0E
Page 3 of 4
©2014 Veris Industries
02141
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
Installation Guide
Temperature
TWS Series
TM
5. Mount the backplate onto the wall using the screws provided.
Five screwholes available; use a minimum
of two for secure mounting.
6. Wire the backplate.
POWER SOURCE
15 to 30VDC or 24VAC
DIGITAL CONTROL
Temp Input
Temp Setpoint Input
Thermistor/RTD Input
Thermistor/RTD Input
-
-
-
+
Temp Output
GND
Temp Setpoint Output
RTD/Thermistor Output
RTD/Thermistor Output
7. Install and configure the sensor.
NOTICE
RISK OF EQUIPMENT DAMAGE
. Ensure that the output selection is correct before applying power.
Failure to follow these instructions may result in permanent
equipment damage.
TEMP
SENSOR
AMP
VOLT
YES
RUN
CAL
NO
TEMP
–
Minus
Select
Plus
+
RUN/CAL Jumper:
CAL Mode - allows full access to all features.
RUN Mode - allows access to relay setpoints ONLY.
TEMP YES/NO Jumper:
YES - allows user to change temp setpoint
NO - user can NOT change temp setpoint
8. When the installation is complete, replace the cover and snap it into position.
Installation (cont.)
