7
VPC7000 INSTALLATION INSTRUCTIONS (CONTINUED)
COMMERCIAL/SPECIAL APPLICATIONS MODEL
CONNECTING STANDARD PUSH-IN FITTINGS
PUSH UP TO TUBBING STOP
PUSH THE TUBBING INTO THE FITTING, TO THE
TUBBING STOP. THE COLLET (GRIPPER) HAS
STAINLESS STEEL TEETH WHICH HOLD THE TUBBING
FIRMLY IN POSITION WHILE THE O-RING PROVIDES A
PERMANENT LEAK PROOF SEAL.
PULL ON THE TUBBING TO CHECK THAT IT IS SECURE.
A GOOD PRACTICE IS TO TEST THE SYSTEM PRIOR TO
LEAVING THE SITE AND/OR BEFORE USE.
DISCONNECTING STANDARD PUSH-IN FITTINGS
ENSURE THE SYSTEM IS DEPRESSURIZED BEFORE
REMOVING FITTINGS. PUSH IN THE COLLET AGAINST THE
FACE OF THE FITTING. WITH THE COLLET HELD IN THIS
POSITION THE TUBBING CAN BE REMOVED. THE FITTING
CAN THEN BE RE-USED.
FLUSHING INSTRUCTIONS
TURN ON THE WATER SUPPLY AND
FLUSH NEW CARTIDGES FOR 5 MINUTES
,
RUNNING WATER THROUGH THE SYSTEM
NEW FILTER ASSEMBLIES MAY CONTAIN “CARBON FINES” AND THE WATER
MAY BRIEFLY APPEAR GRAY, BUT WILL QUICKLY DISAPPEAR ONCE FLUSHED.
IMPORTANT–
CHECK THAT ALL WATER LINES ARE SECURE AND FIRMLY SEATED
WITH NO EVEIDENCE OF WATER LEAKAGE. IF A LEAK IS DETECTED, SHUT OFF
WATER SUPPLY AND DISCONNECT LINES AND VISUALLY CHECK FOR ANY
DEFECTS AT THE END OF LINES. INSERT LINES BACK IN UNTIL FULLY SEATED
AND TURN WATER SUPPLY BACK ON. RECHECK FOR ANY LEAKS.
