30
INSTALLATION
Location
If possible avoid placing the appliance near cookers, radiators or in direct
sunlight as this will cause the compressor to run for long periods. If installed
next to a source of heat or refrigerator, maintain the following minimum
side clearances:
From Cookers
4” (100 mm)
From Radiators
12” (300 mm)
From Fridges
4” (100 mm)
Heat dissipation space
When working, the freezer gives off heat to its surroundings. Therefore,
at least 100mm of free space should be left on both sides. Make sure that
sufficient room is provided around the appliance to ensure free air circulation.
Ideally, A space of no less than 10cm must be left around the freezer, and
ensure you allow gaps as shown in the below diagram.
Protection from moisture
Do not locate the freezer in moist space to avoid the metal parts rusty. And
do not spray water to the freezer, otherwise it will weaken the insulation and
causes current leakage.
Refer to the “Cleaning and Care” section to prepare your appliance for use.
If the freezer is installed in unheated areas such as garages etc., in cold
weather condensation may form on the outer surfaces. This is quite normal.
Remove the condensation by wiping with a dry cloth. It is forbidden to use the
refrigerator outdoors.
Unobstructed ventilation must be maintained around the
appliance or in any embedded structure.