Veripart VPSBS177B, Руководство пользователя, Страница: 66 / 138

66
PROBLEM POSSIBLE CAUSE SOLUTIONS
There is too
much frost and
ice.
- The door is not closed properly.
- The door gasket is deformed or
dirty.
- The products are not packed
correctly.
- The temperature is set incorrectly.
- The appliance is fully loaded and
set to the lowest temperature.
- The set temperature in the
appliance is too low and the
ambient temperature is too high.
- Find the cause of the door not
closing properly, remove or
move possible obstacles.
- As a result, the door does not
close properly. Clean the seal
and repair the deformation.
If necessary, replace the seal,
contact customer service.
- Pack the products better.
- Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
The compressor
works
continuously.
- The temperature is set incorrectly.
- Many products are placed at the
same time.
- The room temperature is too high.
- The food placed in the appliance
was too hot.
- The door is not closed properly.
- Please refer to Section 4.
- Wait a few hours and then
check the temperature again.
- Please refer to Section 4.
- Allow food to cool to room
temperature before storing.
- See the previous section.
The lamp does
not work.
- The lamp is broken.
- The lamp is in the standby
position.
- Please contact our customer
service.
- Close and open the door.
Poor cooling
efficiency
- Do you put hot food or too
much food in the appliance?
- The door does not close
properly.
- Is there direct sunlight or a
stove or heater nearby?
- Is the appliance properly
ventilated?
The temperature set too high?
- Cool hot food before putting
it in the appliance.
- Check the door and door
rubbers and see if the door
is blocked.
- Place the appliance further
away from the heat source.
- Ensure sufficient distance to
ensure proper ventilation.
- Set the appropriate
temperature.