Verint Nextiva S1100w, Руководство пользователя

Страница: 38 / 107

3: Configuring and Installing the Device
26 Verint Video Intelligence Solutions
Installing the Wireless System
After configuring successfully your wireless system, you are ready to install it. To optimize
your system radio performance, carefully review the site planning information presented in
Chapter 2 on page 5. For more information about the installation procedure of your outdoor
wireless access point, refer to the Nextiva S3100 Series User Guide.
Installing the Transmitter
Warning: When installing colocated wireless systems, you have to take into account the
distance limitations listed on page 14.
Warning: Always mount the device with the mating connectors pointing downwards.
Otherwise moisture may penetrate the device; the associated repair costs would
not be covered by the warranty.
To install a transmitter:
1. To install the S1100w on a light pole or mast, use the supplied pole mount brackets and
stainless steel clamps. For wall mounting, use the side brackets already installed on the
device.
2. If you are installing the S1100w equipment in a lightning prone environment or in a site
where large AC mains power fluctuations are a common occurrence, add additional
external surge protection to all vulnerable connections.
Vulnerable connections are those that run for a long distance between the S1100w
device and the connected equipment. For more information about surge protection, see
Appendix E on page 63.
3. If the S1100w device will be directly exposed to the sun in an environment likely to
reach 122°F (50°C), install a sun shield.
A derate of 13°F (7°C) is required to protect the equipment.
4. If required, install an external antenna (see page 27).
5. Apply silicone grease on the mating connector of the CAB9P cable and on the main
connector of the device.
For the detailed procedure, refer to the leaflet shipped with the cable.
Warning: Failure to apply the grease will void the warranty.
6. Connect the CAB9P cable to the S1100w device.
To properly install the cable connector on the device, you have to turn until you feel a
positive click.
7. Plug the BNC video connector of the CAB9P cable on the camera.
8. Perform the serial connection to the camera, if required (see page 27).
9. If you are using a junction box, route all wires to it first; then route the wires from the
box to the target device.
10. Power up the transmitter.